花岗岩残积土动态冲击性能的SHPB试验研究     

刘新宇  张先伟  岳好真  孔令伟  徐超 《岩土力学》2020,41(6):2001-2008

为研究花岗岩残积土的动态冲击性能，开展了高速冲击下的分离式霍普金森压杆（SHPB）试验，与常规应变率下的试验结果比较，分析了高应变率对花岗岩残积土的应力?应变特性和强度的影响。结果表明：低、高应变率下的花岗岩残积土的?-?a（轴向应力?轴向应变）曲线均呈现出软化型。随着应变率 增加，?-?a曲线向?a增大的方向移动，破坏应变?af增加。但高应变率下?af增加的程度更加明显。花岗岩残积土的峰值强度普遍具有应变率依赖性，二者可用直线关系拟合，但低、高应变率下的拟合关系并不一致。提出了率敏性因子m定量评价依赖性强弱。研究发现，随着应变率的提高，强度的应变率依赖性减弱，低应变率下的m为26.694，而高应变率下仅为0.013。相关试验结果指出，高速冲击荷载对土体总体有害。工程中应该采取合理措施控制冲击荷载的危害。该研究有助于深化花岗岩残积土动态冲击性能的理解，为相关工程的施工与设计提供技术参考。  相似文献   

2017-08-09新疆精河Ms6.6地震附近区域相对应变的变化分析     

高丽娟  邢喜民  高歌  李尚伟 《大地测量与地球动力学》2019,39(10):1002-1006

2017年精河M_S6.6地震震前，尼勒克、巴伦台和小泉沟台钻孔应变仪记录到显著的应变变化，经现场落实确认，异常是可靠的。根据这3个台的记录资料计算相对应变的变化，结果表明，地震前最大（小）主应变大小和方向分别出现明显加速和急剧偏转变化。此外还发现，相对应变场异常期间主方向与震源机制解P轴方位较为一致。  相似文献   

鄂尔多斯地块周缘垂直形变场负位错反演与应变积累研究     

张希  刘立炜  郝明  白卓立 《大地测量与地球动力学》2019,39(6):551-556

利用鄂尔多斯地块及其周缘1970～2014年的垂直形变速率场资料，借助负位错反演研究该区域长期应变积累。结果表明，地块东北缘山西断陷带中北段年均能量积累增量、剪应力强度都较高，西南缘六盘山断裂与渭河断裂西段次之；山西断陷带中南段至晋陕交界处年均剪应力强度较高且显示一定程度的能量积累；西秦岭构造区尤其西秦岭北缘断裂西段、晋冀蒙交界区也反映一定程度的能量积累特性。  相似文献   

The recognition of former melt flux through high‐strain zones          下载免费PDF全文

Catherine A. Stuart  Sandra Piazolo  Nathan R. Daczko 《Journal of Metamorphic Geology》2018,36(8):1049-1069

High‐strain zones are potential pathways of melt migration through the crust. However, the identification of melt‐present high‐strain deformation is commonly limited to cases where the interpreted volume of melt “frozen” within the high‐strain zone is high (>10%). In this contribution, we examine high‐strain zones in the Pembroke Granulite, an otherwise low‐strain outcrop of volcanic arc lower crust exposed in Fiordland, New Zealand. These high‐strain zones display compositional layering, flaser‐shaped mineral grains, and closely spaced foliation planes indicative of high‐strain deformation. Asymmetric leucosome surrounding peritectic garnet grains suggest deformation was synchronous with minor amounts of in situ partial melting. High‐strain zones lack typical mylonite microstructures and instead display typical equilibrium microstructures, such as straight grain boundaries, 120° triple junctions, and subhedral grain shapes. We identify five key microstructures indicative of the former presence of melt within the high‐strain zones: (a) small dihedral angles of interstitial phases; (b) elongate interstitial grains; (c) small aggregates of quartz grains with xenomorphic plagioclase grains connected in three dimensions; (d) fine‐grained, K‐feldspar bearing, multiphase aggregates with or without augite rims; and (e) mm‐ to cm‐scale felsic dykelets. Preservation of key microstructures indicates that deformation ceased as conditions crossed the solidus, breaking the positive feedback loop between deformation and the presence of melt. We propose that microstructures indicative of the former presence of melt, such as the five identified above, may be used as a tool for recognising rocks formed during melt‐present high‐strain deformation where low (<5%) volumes of leucosome are “frozen” within the high‐strain zone.  相似文献   

Dynamic modelling of retrogressive landslides with emphasis on the role of clay sensitivity          下载免费PDF全文

Xue Zhang  Scott W. Sloan  Eugenio Oñate 《国际地质力学数值与分析法杂志》2018,42(15):1806-1822

This paper presents a detailed numerical study of the retrogressive failure of landslides in sensitive clays. The dynamic modelling of the landslides is carried out using a novel continuum approach, the particle finite element method, complemented with an elastoviscoplastic constitutive model. The multiwedge failure mode in the collapse is captured successfully, and the multiple retrogressive failures that have been widely observed in landslides in sensitive clays are reproduced with the failure mechanism, the kinematics, and the deposition being discussed in detail. Special attention has been paid to the role of the clay sensitivity on each retrogressive failure as well as on the final retrogression distance and the final run‐out distance via parametric studies. Moreover, the effects of the viscosity of sensitive clays on the failure are also investigated for different clay sensitivities.  相似文献   

Equivalent continuum strain calculations based on 3D particle kinematic measurements of sand          下载免费PDF全文

Siavash Amirrahmat  Khalid A. Alshibli  Maha F. Jarrar  Boning Zhang  Richard A. Regueiro 《国际地质力学数值与分析法杂志》2018,42(8):999-1015

Constitutive modeling of granular materials has been a subject of extensive research for many years. While the calculation of the Cauchy stress tensor using the discrete element method has been well established in the literature, the formulation and interpretation of the strain tensor are not as well documented. According to Bagi, 1 researchers mostly adopt well‐known continuum or discrete microstructural approaches to calculate strains within granular materials. However, neither of the 2 approaches can fully capture the behavior of granular materials. They are considered complementary to each other where each has its own strengths and limitations in solving granular‐mechanics problems. Zhang and Regueiro 2 proposed an equivalent continuum approach to calculating finite strain measures at the local level in granular materials subjected to large deformations. They used three‐dimensional discrete element method results to compare the proposed strains measures. This paper presents an experimental application of the Zhang and Regueiro 2 approach using three‐dimensional synchrotron microcomputed tomography images of a sheared Ottawa sand specimen. Invariant Eulerian finite strain measures were calculated for representative element volumes within the specimen. The spatial maps of Eulerian octahedral shear and volumetric strain were used to identify zones of intense shearing within the specimen and compared well with maps of incremental particle translation and rotation for the same specimen. The local Eulerian volumetric strain was compared to the global volumetric strains, which also can be considered as an averaging of all local Eulerian volumetric strains.  相似文献   

Hypo‐elastic and hyper‐elastic equations of soils          下载免费PDF全文

Koichi Hashiguchi 《国际地质力学数值与分析法杂志》2018,42(13):1554-1564

  相似文献   

青岛台体应变短周期气压系数变化原因探讨     

岳龙  徐清风  臧艺博  李志强  刘云  李炜  孙忠礼 《大地测量与地球动力学》2020,40(7):765-770

青岛台体应变短周期(小于128 min)气压系数2018-01出现阶变，通过对观测系统、台站周边施工情况、监测环境等逐项现场核实，排除观测系统、周边施工的影响。利用离散小波变换和回归分析发现，钻孔水位的气压系数与体应变气压系数同步阶变，结合台站钻孔施工当天体应变钻孔水位变化、体应变趋势变化、其他相邻台站水位气压系数变化等数据认为，台站钻孔施工是导致体应变气压系数变化的原因，并定性分析其变化机理。  相似文献   

鄂尔多斯盆地南缘黄陵地区煤铀兼探钻孔数据集成与三维地质模型构建          下载免费PDF全文

张云  张天福  孙立新  程银行  张祺  王少轶  程先钰  周小希 《中国地质》2020,47(S1):231-240

鄂尔多斯盆地南缘黄陵地区铀成矿前景良好。中国地质调查局在该地区组织实施了含铀岩系三维地质调查工作，以寻找可地浸砂岩型铀矿找矿靶区为目标，采用“煤铀兼探”、“油铀兼探”的新思路，对煤田钻孔资料进行“二次开发利用”，开展勘查选区研究，完成了354口煤田钻孔（其中筛选出潜在砂岩型铀矿（化）孔49口）和21口铀矿验证钻孔（其中工业矿（化）孔16口）的数据采集建库，在此基础上建立了专题成果图集及三维地质模型。该数据库主要由含铀岩系地层厚度等值线图、砂体厚度等值线图、顶底板埋深等值线图、含砂率等值线图、放射性异常等值线图等专题成果图集和三维地质结构模型组成，为铀矿勘探开发提供了有利支撑和服务作用。  相似文献   

A novel coupled FDM-DEM modelling method for flexible membrane boundary in laboratory tests     

Hua-Xiang Zhu  Zhen-Yu Yin  Qiang Zhang 《国际地质力学数值与分析法杂志》2020,44(3):389-404

Difficulties are involved in discrete element method (DEM) modelling of the flexible boundary, that is, the membranes covering the soil sample, which can be commonly found in contemporary laboratory soil tests. In this paper, a novel method is proposed wherein the finite difference method (FDM) and DEM are coupled to simulate the rubber membrane and soil body, respectively. Numerical plane strain and triaxial tests, served by the flexible membrane, are implemented and analysed later. The effect of the membrane modulus on the measurement accuracy is considered, with analytical formulae derived to judge the significance of this effect. Based on an analysis of stress-strain responses and the grain rotation field, the mechanical performances produced by the flexible and rigid lateral boundaries are compared for the plane strain test. The results show that (1) the effect of the membrane on the test result becomes more significant at larger strain level because the membrane applies additional lateral confining pressure to the soil body; (2) the tested models reproduce typical stress and volumetric paths for specimens with shear bands; (3) for the plane strain test, the rigid lateral boundary derives a much higher peak strength and larger bulk dilatation, but a similar residual strength, compared with the flexible boundary. The latter produces a more uniform (or ‘diffuse') rotation field and more mobilised local kinematics than does the former. All simulations show that the proposed FDM-DEM coupling method is able to simulate laboratory tests with a flexible boundary membrane.  相似文献